Too many people take their steaks directly from the chilly fridge to the hot fire. You will not get an evenly cooked steak this way—the outside of the meat will cook faster than the inside. It is best to take the steaks out of the fridge about half an hour before you plan to cook them; remove the wrapping, place on a plate, and let them come up to room temperature on the kitchen counter.
New grills oftentimes come with pre-seasoned grates, however, for those looking to care for an old favorite or cast-iron grates with build-up of cooked-on drippings, follow these simple steps to completely re-season or maintain the regular care of your BBQ grill. Seasoning grill grates is not only a good way to care for and prolong the life your your grill, but ensures the food you’re cooking is free from carcinogens and at its tastiest every single time.
While the grill grates and flavorizer bars are removed and soaking, tackle the caked-on gunk in the firebox. Put another bucket underneath the firebox where the grease tray sits to collect debris. The easiest way to start is with a wet/dry shop vacuum, whether full-size or a portable, like Milwaukee’s M18 hand vacuum. Since wet/dry vacs are mostly workshop items, you won’t feel bad about using one to suck up the gunk that’s collected in your grill. You can use the grill brush to help loosen stubborn stuck-on grit. If the deposits are really caked on, dip the wire brush in the bucket of soapy water and get to work. Use a hose to rinse it out when it’s clean.
Perhaps the most important step that most people don't do is allowing the steaks to sit once they are taken off of the grill. The steaks need to rest for 5 to 10 minutes before serving or cutting them. This gives the juices a chance to redistribute throughout the steak, which both helps it finish cooking evenly and keeps the meat moister and more flavorful. Place the cooked steaks on a cutting board or platter and tent loosely with aluminum foil. Once rested, either slice or serve the steaks whole.
Check the ignition system. Turn the gas off, and test your ignition button to see if it creates a spark. If both the pressure regulator on the gas tank and the ignition system are running normally (meaning the pressure regulator is tracking and maintaining correct gas tank pressure, and the ignition system is sparking and lighting correctly), you can finish testing the grill by turning the gas back on and lighting the grill up as you normally would.