Yes, you should touch the steaks to test for doneness, but that doesn't mean that you should be flipping and moving and poking a lot. Steaks should only be flipped once, and only moved once from a higher to a lower heat. And don't poke them with anything but your finger! Put the meat on a hot grill—they should sizzle immediately—and leave them there until they release on their own accord. If you're pulling or struggling with them, they are not seared and not ready to flip.
No matter what you are grilling, you should always begin with clean grill grates. Not only does this make it easier to flip and remove the food from the grill but it also does not impart any flavors from previous grilled meals, such as barbecued chicken, into the steaks. Make sure to clean your cooking grate using a stiff wire brush. It is best to do this after you've finished grilling while the grates are still warm, but you can also clean the grill while it is preheating if you discover caked on residue. Taking the time to brush off old bits of cooked-on food will pay off handsomely when your steaks release from the cooking grate with ease.
Learning how to clean your gas grill is important. Whether it’s before or after grilling out or even preparing for winter, there are a few helpful tips and tricks that can make cleaning a grill easy and efficient. The Home Depot is your source for all of your grill cleaning needs. We have grill brushes, grill cleaners, grill cleaning pads, and so much more.
To achieve a crust on the outside while keeping the interior of the steak cooked to your liking, you need to have two different temperatures set on your grill. In order to get those nice grill marks, you need to heat your grill to high heat to essentially sear the steaks. To determine the heat is hot enough, you should be able to hold your hand about an inch over the grill grate for 1 second before it feels too hot and you must pull it away.
Clean out the burners and venturi tubes. The venturi tubes are the pipes that go out from the burners and connect to the grill control valves. These tubes allow the air and gas to mix together, altering the intensity of the flame. Remove the burners and venturi tubes, and place a hose head at one end of the tube. Turn the water on to clear out any debris or insects that could have gotten inside.