Inspect your burners for signs of corrosion or anything blocking the row of flame holes. Burner tubes are inviting spots for spiders to lay eggs if your grill goes unused for a while. Use a wire brush and clean them by brushing back and forth over the holes, not down the length of the tube. The wire bottle brush can clean out the inside of each tube.
The trick with seafood is to make sure it doesn’t stick. So coat it lightly with oil and check that the grate is clean and very hot. For fillets and whole fish, you can also try this foolproof (albeit more time-consuming) method: Place the fish on a soaked cedar plank or a lightly oiled piece of heavy-duty foil, then grill (covered), over medium indirect heat.
It seems that people approach grilling steak one of two ways: either in a casual manner or paying perhaps too much attention. Some will heat the grill with abandon, throw the steaks on, flip once, then pull them off, and serve; others will fret and worry, cutting into the meat every two seconds wringing their hands over whether the meat is done or not. Both techniques do have some merits but a method somewhere in the middle is ideal.
Check the fuel lines for visible defects. If any fuel lines have unmistakable damage (like rips, holes, cracks), replace the parts immediately before your next use of the grill. Also be sure that any fuel lines have a smooth trail. You don’t want any of your fuel lines to be bent, because that will prevent the gas from flowing correctly. Check the exterior of the gas tank for any damage as well; things like dents, erosion, punctures, or any evident signs of damage. If you find areas that have obvious damage, you could potentially have a gas leak.