In lieu of fully re-seasoning your grill with each use, there are simple steps you can take to maintain and care for the condition of your grates. After each use, take a moment to run the wire brush quickly over the grates to clear away any immediate drippings. The heat in this case is helpful for removal when in smaller portions and in the moment. In the same step as above, use a pair of kitchen tongs and a paper towel to coat a layer of high heat oil over the cleaned grates before closing the grill top to cool.
Try to avoid this if you can, but if you just have to take a peek, remove the steak from the grill and use the tip of a paring knife to make a cut into the center of the steak to see how things are going. Keep in mind that the steak will continue to cook as it rests after being removed from the grill. Cutting into the steak is discouraged because it will release the precious juices that help flavor and tenderize the meat.
With the grates removed, brush down the inside to clear out any loose particles that have collected in the bottom and around the sides. Scrape off any large peeling flakes of carbon and grease and if yours is a charcoal grill, empty the ash catcher. Don’t forget to clean the drip pan and grease cup in warm soapy water and line them with aluminum foil so they’ll be easier to clean next time.
Clean the bottom of the grill with a soapy sponge. Once all the chunks are gone, scrub the bottom with a sponge or scouring pad and soapy water to remove any built up grease or grime. Lots of drippings and food scraps tend to build up under the burners of the grill. Pay close attention to this area and clean it as much as possible to avoid corrosion.